Infinite Roofing Solutions serves Fresno and the Central Valley. We install Fluid Applied Roofing and repair and replace commercial roofs. Fluid Applied Roofing forms a new roof over the existing one, as one continuous membrane. There’s no tear-off, and your business doesn’t have to shut down.
Call (559) 550-6398. No pitch. No pressure.
| Option | When it usually fits | What we check first |
|---|---|---|
| Repair | A leak at a seam, curb or pipe, on a roof that’s otherwise sound. | Where the water is actually getting in. We check every seam, curb and penetration. |
| Fluid Applied Roofing | A flat or low-slope roof, or a metal roof, that’s aging but still structurally sound, when you want a new roof without a tear-off. | The condition of the existing roof and whether the deck is dry. It has to be dry before the system goes on. |
| Replacement | The deck is damaged, or the roof is too far gone for repairs or a roof over the top. | The deck and how much of the roof is failing before we recommend replacing it. |
Fluid Applied Roofing goes over the roof you already have. It’s a full roofing system made by Fluid Applied Roofing LLC in Dayton, Ohio. We install it.
We apply it in layers. Primer and caulk go on first, followed by a sprayable fiber-reinforced base coat in place of fabric and seam tape. A silicone or ProCoat finish coat goes on top. The layers cure into one continuous membrane, without joints, seams or fasteners for water to get through. Seams are among the most common leak points on flat roofs.
The existing roof stays in place, so there’s no tear-off. There’s no demolition, no disposal fees and no waste going to a landfill. Your business doesn’t have to shut down. Most installs take 1 to 5 days, depending on the size of the roof.
The system can go over built-up (tar and gravel), modified bitumen, TPO, PVC, EPDM, metal and spray foam roofs. Its finish reflects sunlight and can lower the roof’s surface temperature by up to 50°F. The silicone finish handles ponding water. The system is designed to extend the roof’s life by 15 to 20 years, and it can be recoated later. It comes with a manufacturer-backed warranty of 10 to 20 years, depending on the system.
Our crews inspect industrial buildings, storage properties and retail buildings, along with other commercial roofs across the Central Valley. These are three of the roofs they’ve inspected.
Get a FREE Roof Assessment of your commercial roof. We check the roof first and tell you honestly which option fits.
Yes. It’s a full roofing system rather than a surface treatment. The fiber-reinforced base coat takes the place of fabric and seam tape, with a finish coat applied over it. The layers cure into one continuous membrane over the existing roof.
No. We need to inspect the roof first. On the large flat roof in Dinuba, the crew checked the laps and drains, along with the curbs around the rooftop equipment, before any work was proposed. Whether the system fits depends on the roof’s condition and how dry the deck is. We’ll tell you if it doesn’t fit.
Often, yes. The roofs at a Fresno self-storage property were in different condition from one building to the next. The crew checked each one separately and recommended work where it was needed, rather than treating every roof the same.
Check the seals at every curb, pipe and seam. Water commonly gets in at those spots. On a Fresno industrial building, the curbs and pipe bases were sealed in April. Resealing doesn’t fix every leak. We find where the water is getting in before deciding what to do.
Schedule it while conditions are dry, before the rains. The roof has to be dry before we apply the system.
No. The existing roof stays in place, so there’s no tear-off or demolition and no need to close the business. Most installs take 1 to 5 days, depending on the size of the roof.
Call (559) 550-6398 for a FREE Roof Assessment · 7am–7pm, 7 days a week
Infinite Roofing Solutions · Licensed contractor, CSLB #1126804
