Infinite Roofing Solutions serves commercial building owners across the Bay Area. We install Fluid Applied Roofing and handle roof repair and replacement. Fluid Applied Roofing forms a new roof over the existing one, as one continuous membrane. There’s no tear-off, and your business doesn’t have to shut down.
Call (415) 463-3419. No pitch. No pressure.
| Option | When it usually fits | What we check first |
|---|---|---|
| Repair | A leak at a seam, curb or pipe, on a roof that’s otherwise sound. | Where the water is actually getting in. We check every seam, curb and penetration. |
| Fluid Applied Roofing | A flat or low-slope roof, or a metal roof, that’s aging but still structurally sound, when you want a new roof without a tear-off. | The condition of the existing roof and whether the deck is dry. It has to be dry before the system goes on. |
| Replacement | The deck is damaged, or the roof is too far gone for repairs or a roof over the top. | The deck and how much of the roof is failing before we recommend replacing it. |
Fluid Applied Roofing goes over the roof you already have. It’s a full roofing system made by Fluid Applied Roofing LLC in Dayton, Ohio. We install it.
We apply it in layers. Primer and caulk go on first, followed by a sprayable fiber-reinforced base coat in place of fabric and seam tape. A silicone or ProCoat finish coat goes on top. The layers cure into one continuous membrane, without joints, seams or fasteners for water to get through. Seams are among the most common leak points on flat roofs.
The existing roof stays in place, so there’s no tear-off. There’s no demolition, no disposal fees and no waste going to a landfill. Your business doesn’t have to shut down. Most installs take 1 to 5 days, depending on the size of the roof.
The system can go over built-up (tar and gravel), modified bitumen, TPO, PVC, EPDM, metal and spray foam roofs. Its finish reflects sunlight and can lower the roof’s surface temperature by up to 50°F. The silicone finish handles ponding water. The system is designed to extend the roof’s life by 15 to 20 years, and it can be recoated later. It comes with a manufacturer-backed warranty of 10 to 20 years, depending on the system.
Not every commercial roof is flat, and some have more than one roofing material. Our crews have been on these two Bay Area buildings, one in Hayward and one in Cloverdale.
Get a FREE Roof Assessment of your commercial roof. We check the roof first and tell you honestly which option fits.
Yes. The Hayward building we inspected has pitched shingle sections and a flat section. We look at each part separately. A fix that suits one part may not suit the other.
We check the patches and flashing, along with every penetration around the equipment. On the Hayward building, the crew found old patch work near the exhaust units and a covered curb. Neither an old patch nor a reported leak tells us where water is entering. We trace that first.
The rust needs to come off before anything goes over it. On the commercial metal roof in Cloverdale, the crew ground off the rust and pressure washed the roof. The proposal also called for detail work at seams, fasteners and penetrations.
Yes. It can go over metal and standing seam roofs as well as flat roofs. Commercial roofs aren’t always flat. The Cloverdale building has a pitched metal roof.
Look at how the roof will be cleaned and prepared. Check how the proposal handles seams, fasteners and penetrations, which system will be installed and what warranty comes with it. Ask for those details in writing.
No. The existing roof stays in place, so there’s no tear-off or demolition and no need to close the business. Most installs take 1 to 5 days, depending on the size of the roof.
Call (415) 463-3419 for a FREE Roof Assessment · 7am–7pm, 7 days a week
Infinite Roofing Solutions · Licensed contractor, CSLB #1126804
